Western Horizon - Colvic Watson 26
£18,950 (GBP)
Archive
Model: Colvic Watson 26
Price: £18,950 (GBP)
Year: 1980
Hull: GRP
Scroll down to see all 44 images.
Archive
Model: Colvic Watson 26
Price: £18,950 (GBP)
Year: 1980
Hull: GRP
LOA: 30' 0" (9.1m)
LOD: 25' 6" (7.8m)
LWL: 22' 1" (6.7m)
Beam: 9' 0" (2.7m)
Draft: 3' 4" (1m)
Displacement: 9000lbs
Ballast: 4460lbs
Keel: Long with bilge plates
Rig: Bermudan cutter
Engine Type: BMC 1500 35hp
Engine: Inboard diesel
Fuel: Diesel
Fuel Capacity: 35gal
Water: 37gal
Location: Lancashire
A sturdy yet comfortable Motor Sailer with full standing headroom throughout.
She is in excellent condition thanks to a dedicated owner who has constantly carried out improvements.
She has cruised extensively in The Irish Sea, North Wales coastal and Scottish waters.
The BMC engine has undergone a complete re build, with only 746 hrs running since then.
The rig has been converted to cutter rig with a new furling yankee, and staysail.giving enhanced sailing performance.
Other recent improvements carried out include a new DSC radio (2007), new water tank,
and new 3 bladed propeller (2008).
In 2009 a new Lavac toilet and holding tank were fitted.
The cutlass bearing was also replaced.
The windlass on the foredeck is electric powered.
Accommodation:
A total of four berths, with two single berths in the forward cabin and two hanging lockers,
A double berth in the saloon.
A Separate heads compartment fitted with a new Lavac toilet connected to a holding tank.
Eberspacher heating.
Galley:
Eastham Maxol cooker, with two burners grill and oven.
Gas water heater.
Sink with hot and cold water.
Sails:
Yankee 2005 (furling)
Staysail 2005 (furling)
Main sail all good condition.
Instruments:
Nasa target log, Nasa target depth, MLR GPS, Icom M421 DSC radio, Auto helm ST3000
Electrical System:
2x12v 100 amp hour batteries with shore power.
Equipment:
Anchor and chain, 2x bilge pumps.
Sail cover, 2x gas bottles, emergency steering.
Additional Info:
Hull number 7302
Starboard side - She is stored ashore at present
The view from the starboard bow -
The view from the port bow - Note the twin head sails and the plank bow sprit
Seen from port side - Sorry about the congestion in the yard
The view from astern - Note the stern boarding ladder
Another stern view - Note the stern boarding ladder
Aview of the rudder - And the new three bladed propeller
Looking aft - The starboard side below the waterline
The view from the bow - Looking aft below the waterline very clean
Looking forwards - Along the starboard side deck
Lookin forwards - From the cockpit
The fore hatch -
The twin headsails - The furling gear for the headsails, and the plank bow sprit
Pulpit view - With the furling gear for the yankee
The fore deck - Note the electric windlass, and twin jackstays
Looking aft - To the ample wheelhouse
The main sail cover -
The view looking down the port side deck - Note the wipers on the wheel house windows
The cockpit - Before the cockpit cushions are fitted
The cockpit - With the cockpit cushions in place
Another cockpit view - The small hatch gives access to the steering gear
General view of the wheelhouse - Note the internal helm position
The saloon - Port side view
The port side of the saloon - Note the fitting for the saloon table leg
The wheelhouse - Seating for skipper and crew with good shelter
The helm - With instruments
The helm - With a good seating position
The galley - Equipped with gas cooker, sink and gas heater
Another view of the galley - Note the cooker etc
The gas heater - Situated above the sink in the galley
The heads compartment - The loo is a new lavac, there is a holding tank
The fore cabin - Offers two single berths
A hanging locker -
Looking aft - Into the saloon from the forecabin
The engine room - Access is good
Instruments - The log and depth sounder
The autohelm -
The twin gas bottles - In the starboard cockpit locker
The gps - Invaluable
The engine - As seen from aft
Another engine view - The engine has undergone a professional rebuild recently
Owners Photo - Under sail
Owners Photo -
Owners Photo -
Archive
Model: Colvic Watson 26
Price: £18,950 (GBP)
Year: 1980
Hull: GRP
LOA: 30' 0" (9.1m)
LOD: 25' 6" (7.8m)
LWL: 22' 1" (6.7m)
Beam: 9' 0" (2.7m)
Draft: 3' 4" (1m)
Displacement: 9000lbs
Ballast: 4460lbs
Keel: Long with bilge plates
Rig: Bermudan cutter
Engine Type: BMC 1500 35hp
Engine: Inboard diesel
Fuel: Diesel
Fuel Capacity: 35gal
Water: 37gal
Location: Lancashire
Content © Western Horizon 2007-2021
Website © BlueWave Projects and Services 2015-2021